New Version Micro Jet Rinse Bar 16 – 26cm

From £17.50

New Version Micro Jet Rinse Bar 16 – 26cm

New Version - 16 Micro Jet Rinse Bar

£17.50

New Version – 16 Micro Jet Rinse Bar

You can choose a minimum quantity of 1 and a maximum quantity of 5 for this product!

5 in stock

Push Fit T- 4 jets with Jet Hose

£6.45

Push Fit T- 4 jets only

You can choose a minimum quantity of 0 and a maximum quantity of 5 for this product!

16 in stock

Push-Fit T Connector for QuicK-LoQ System - With Jet Hose

£1.95
You can choose a minimum quantity of 0 and a maximum quantity of 5 for this product!

Out of stock

16mm Socket Screw Set

£0.40

16mm Socket Screw Set

You can choose a minimum quantity of 0 and a maximum quantity of 5 for this product!

147 in stock

19mm Socket Screw Set

£0.40

19mm Socket Screw Set

You can choose a minimum quantity of 0 and a maximum quantity of 5 for this product!

32 in stock

Description

New Version – 16 Micro Jet Rinse Bar

  • New Single Piece version with improved internal water flow path
  • 16 micro jets provide precise but gentle rinsing with brush on the glass
  • Fits between brush and brush socket on any standard width (26cm) Gardiner brush (not the Supreme)
  • Provides over-bristle micro jet rinsing
  • Flow rate is about equivalent to a pair of standard pencil or Fanjets – recommended 1.5 – 2lpm
  • Jet angle is 3° higher than high flow rinsebar to allow for lower flow rates
  • Height of rinse bar can be adjusted
  • Can be used with internal brush jets as well
  • Lightweight at 41g
  • Uses John Guest connections on unit
  • Uses standard Brush T Connector and jet hose – optional extra
  • Needs 2 longer screws to allow it to be attached between brush body and brush socket (if used on standard brushes, will need 19mm screws. if used on Xtreme will need 16mm)
  • Please note: The rinse bar does not come with the brush pictured

Screw Choice:

    1. If using on Ultimate, Super-Lite & Universal brushes then the standard 16mm screws will need replacing with 19mm screws
    2. If using on Xtreme brushes then the standard 13mm screws will need replacing with 16mm screws